Milwaukee-tool 6577-20 User Manual download pdf (Page 7)

NOTE: Do not remove inner blade ange. Large

diameter of inner ange (Fig. 3) should face the

blade.

Fig. 1

Rip & Crosscut

A multi-purpose blade for ripping, cross cut-

ting and mitering in hardwoods, softwoods,

plywood and composition materials.

Framing-Rip

Designed for fast and accurate ripping along

the grain in hard-or softwoods where a smooth

cross cut is not necessary.

Plywood-Veneer

Recommended for cutting plywood, composi-

tion materials and all types of wood where a

slightly smoother nish is needed.

Finish & Trim

Especially designed for cross cutting and

mitering in materials where a very smooth cut

is necessary. Also cuts aluminum.

3. Push lower guard lever up to raise lower guard

(Fig. 4). Place blade on spindle with teeth point-

ing the same direction as the arrow on lower

guard. Release lower guard lever.

Fig. 2

51.5

Spindle

lock

button

Installing Blade

1. Unplug tool.

2. To remove blade bolt from spindle, push in

spindle lock button (Fig. 2) while turning bolt

clockwise with 6 mm hex wrench (provided with

tool) until spindle locks. Remove outer blade

washer and spring washer.

Fig. 3

Inner

blade

ange

Blade

Spring

washer

Blade

bolt

Outer

blade

washer

Fig. 4

Lower

guard

lever

application. Using the wrong blade may result in

reduced performance or damage to the blade. Do

not use blades that are cracked or have broken

teeth. Do not sharpen ferrous metal cutting blades;

see the blade manufacturer's recommendations

regarding sharpening.

Checking the Operation of the Lower Guard

Check the operation and condition of the lower

guard lever. If the guard and the lever are not op-

erating properly, they must be serviced before use.

Lower guard may operate sluggishly due to dam-

aged parts, gummy deposits, or a buildup of debris.

1. Unplug tool before checking the lower guard.

2. Place the tool on its side.

NOTE: This procedure will not show proper lower

guard operation if the tool is not on its side.

3. Grasp the lower guard by the sides and push it

all the way back into the blade housing.

4. Release the lower guard.

• If the guard immediately springs back into

place, it is working correctly and you may

continue with use.

• If the guard does not immediate spring back

into place, clean the upper and lower guards

to remove all chips and debris. Then, check

the operation again by starting with step 1.

• If the guard still does not immediately spring

back into place, contact a MILWAUKEE service

facility for repairs.

4. Place outer blade washer, spring washer, and

blade bolt on spindle.

5. Push in spindle lock button while turning bolt

counterclockwise with 6 mm hex wrench until

spindle locks. Tighten bolt securely.

1 2 3 4 5 6 7 8 9 10 11 12 ... 39 40

Comments to this Manuals

No comments

Milwaukee-tool 6577-20 User Manual Page 7

Comments to this Manuals

Related products and manuals for Power saws Milwaukee-tool 6577-20